APC Power Saving Back-UPS ES 8 Outlet 700VA 230V

SKU: APC-BE700G

More Views

Where to Buy?

Details

Provides the ability to adapt the UPS for optimal performance in specific power environments or generator applications.
Provides notification of changing utility power and UPS power conditions
Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Provides early-warning fault analysis on batteries enabling timely preventive maintenance
Enables fast battery replacement, lowering Mean Time to Repair (MTTR).
Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment
Provides temporary battery power when the utility power is out.
Provides protection of connected equipment from power surges on the data lines.
Ensures clean, uninterrupted power to protected equipment while batteries are being replaced
Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
Provides management of the UPS via a USB port (not available on all models).
Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)

UPS Promotion July 2016

Features

Protection

Battery and surge protected outlets:Back up and protect your hardware and data during power outages, surges and spikes.
Surge only outlets:Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.

Manageability

Audible alarms:Provides notification of changing utility power and UPS power conditions
LED status display:Quickly understand unit and power status with visual indicators.

Safety

Safety-agency approved: Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

Marketing Features

Battery-protected and surge-only:outletsReserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment

Availability

Automatic self-test: Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Intelligent battery management: Maximizes battery performance, life, and reliability through intelligent, precision charging.
Battery failure notification: Provides early-warning fault analysis on batteries enabling timely preventive maintenance

Specifications

Output

Output power capacity: 405 Watts / 700 VA
Max Configurable Power (Watts): 405 Watts / 700 VA
Nominal Output Voltage: 230V
Output Frequency (sync to mains): 47 - 63 Hz
Output Frequency (not synced):50Hz +/- 0.1% for 50Hz nominal
Other Output Voltages: 220
Waveform type: Stepped approximation to a sinewave
Output Connections:
- (4) Australian (selector_surgetitle)
- (4) Australian (Battery Backup)
Output Voltage Tolerance: +/- 5% static and 100% load step
Transfer Time: 6ms typical: 10ms maximum

Input

Batteries & Runtime

Battery type: Maintenance-free sealed Lead-Acid battery with suspended electrolyte: leakproof
Typical recharge time: 16 hour(s)
Replacement Battery: RBC17
Battery Volt-Amp-Hour Capacity: 86
Runtime: View Runtime Graph

Communications & Management

Interface Port(s):USB
Control panel: LED status display with On Line: On Battery: Replace Battery and Overload indicators

Surge Protection and Filtering

Surge energy rating:310 Joules
Data Line Protection:Analog phone line for phone/fax/modem/DSL (RJ-45 connector), Network line - 10/100 Base-T Ethernet (RJ-45 connector)
Filtering: Full time multi-pole noise filtering: 5% IEEE surge let-through: zero clamping response time: meets UL 1449

Physical