Welcome to Anyware! Login or Register

Call: 1300 269 927

Yale Wireless PIR

SKU: YALE-22120

Yale Wireless PIR

More Views

  • Ideally placed in the corner of any room
  • When the alarm is set, the infra-red sensor will pick up movement and activate the siren and any communications pre-configured
  • For use on extra rooms that need protection, such as lounge, bedroom or extension
  • Suitable for garages & outbuildings
Details
  • Learn/Test Button
    • To enter Test mode: Press once in Standby mode.
  • The LED will light up for two seconds whenever a movement is detected. Test mode lasts for 3 minutes.
  • LED Indicator
  • Knockouts for Wall / Corner Mounting
  • Tamper Switch with spring
  • 3x 1.5V AAA Alkaline Battery
  • Top & Bottom Cover securing screw hole
Features
  • Ideally placed in the corner of any room
  • When the alarm is set, the infra-red sensor will pick up movement and activate the siren and any communications pre-configured
  • For use on extra rooms that need protection, such as lounge, bedroom or extension
  • Suitable for garages & outbuildings
  • 2 Year Warranty
Specifications
Sleep Timer
  • The PIR features an automatic “sleep time" of approximately one minute for power conservation. After transmitting a detected movement, the PIR will not retransmit for one minute. Any further movement detected within this one-minute sleep period will extend the sleep time by another minute. Disable the sleep timer temporarily by entering the test mode. See Test Mode section.
LED indicator
  • Off: Normal operation
  • LED flash (2 sec) - Detects motion during Low battery, -Tamper activated or Test mode. -Spring tamper switch is activated.

Supervision Enable/Disable Jumper 2

  • If enabled, the PIR will automatically transmit Supervisory signals periodically to the Control Panel at random intervals. The Control Panel needs to enable supervision before it can monitor these periodic signals.
  • Jumper On = Supervision Disabled (Default)
  • Jumper Off = Supervision Enabled

Specification

  • Environmental conditions: -10c to 40c, relative humidity 85% non-condensing. Indoor use only
  • Radio: 433MHz FM

Movement High/Low Sensitivity Jumper 3

  • Jumper On = Increase PIR sensitivity to movement
  • Jumper Off = Decrease sensitivity (Factory Default)

Programming & installation

  • Program your PIR before installation and test afterwards. Please see your current system instruction book.

Pack contents

  • 1 x PIR motion detector.
  • 4 x wall plugs & screws.
  • 3 x 1.5V AAA alkaline cells (pre-fitted).